Altana Gardner-Scrub Manual Bedienungsanleitung Seite 1

Additives & InstrumentsA member ofGardner-scrubAbrasion TesterMeasure what you see.Manual

When the pause button is pressed (or anywhere except the Stop button area) This Pause screen will appear. To resume the test just press the yellow Run

Components Ordering Information Catalog Number Description 5060 Gardner-scrub Abrasion Tester basic instrument 5061 Gardner-scrub Abrasion Tester

7 Technical Data Weight 25 pounds 11.3 kg Height 7.7 inches 196 mm Width 19.1 inches 485 mm Depth 11.0 inches 279 mm Temperature - Storage

Appendix A – ASTM Test Setup The ASTM brush and holder is easy to install and quite versatile. This guide is intended to help the user set up the Gar

Up to three brushes may be run at the same time. Additional weights of 500 and 1000 grams are available to put extra pressure on the brus

Appendix B – ISO test setup The ISO accessory kit includes an adapter and pad holder for using abrasive pads with the Gardner-scrub. This guide is in

EC – Declaration of Conformity EG – Konformitätserklärung We / Wir, BYK-Gardner USA, 9104 Guilford Road, Columbia, Maryland, USA declare in accord

298 023 140 E 1408

Gardner-scrub Abrasion Tester Instruction Manual BYK-Gardner USA BYK-Gardner GmbH 9104 Guilford Road Lausitzer Str. 8 Columbia,

1 Safety Information Caution! Read Instruction Manual before using this instrument. Warning! This manual cannot address all of the safety conside

2 Preparations Unpack the unit being careful to check all packaging for items. Some accessories required for specific tests may be found in a separ

Pull out the shaft by lifting the spring Grasp the shaft and tighten the knob fully 3 System Description The Gardner-scrub Abrasi

The Gardner-scrub incorporates a precise speed control to maintain a constant speed for the test. The instrument is preset at 37 strokes per minute to

All user interaction is through the touch screen LCD. The Home screen The large number in the center indicates number of counts, the small arrow ind

Set Count screen This setting allows the instrument to count up or down from the number of cycles set previously. The default is counting up from zero

5 Operation Specific brushes, holders or other apparatus is specified in the various international standards and those should be referenced to setup