Altana Byko-Test MP0R Bedienungsanleitung PDF herunterladen (Seite 20)

3. Perform three to five measurements on the uncoated specimen.

The current reading appears on the display after each measurement.

4. Press button [OK].

Note: When pressing [OK], the mean value of all measurements is used as the normalization value.

This mean value is set to 0. The display shows 0.00.

STD1 (that is, calibration standard # 1) appears on the display.

5. Measure at least two times on the uncoated specimen. A reading will appear.

6. Use button [] or [] to set the displayed value to 0.00.

7. Press button [OK]. The baseline of the characteristic is restored.

Ready. The instrument is again ready to measure, but you must do a corrective calibration prior to measuring.

Cf. Chapter

8 Calibration.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 41 42

Keine Kommentare

Altana Byko-Test MP0R Bedienungsanleitung Seite 20